Pfeiffer Vacuum HiCube 300 H Pro, Руководство по эксплуатации

Страница: 51 / 80

10 Malfunctions
10.1 General
WARNING
Danger to life from the turbopump breaking away in the event of a fault
Sudden jamming of the rotor generates high destructive torques in accordance with ISO 27892. If the
turbopump is
not properly secured, it can shear off. The energy that this would release could throw
the entire turbopump or shattered pieces from its interior through the surrounding space. Potentially
dangerous gases can escape. There is a risk of very serious injuries, including death, and extensive
property damage.
► Follow the installation instructions for this turbopump.
► Observe the requirements regarding stability and design of the counter flange.
► Use only original accessories or fixing material approved by Pfeiffer Vacuum for the installation.
WARNING
Risk of injury caused by the turbopump breaking away with the vibration compensator in the
event of a malfunction
Sudden jamming of the rotor generates high destructive torques in accordance with ISO 27892.
When using a vibration compensator, this will probably lead to the turbopump being sheared off in
use. The energy that this would release could throw the entire turbopump or shattered pieces from its
interior through the surrounding space. Potentially dangerous gases can escape. There is a risk of
very serious injuries, including death, and extensive property damage.
► Take suitable safety precautions on-site for the compensation of the occurring torques.
► Before installing a vibration compensator, you must first of all contact Pfeiffer Vacuum.
Malfunctions on the pumping station are usually caused by faults on individual components. LEDs on
the turbopump and backing pump indicate the operation statuses for the respective device.
● The DCU display and control unit indicates basic pumping station operating statuses
(see chap-
ter “Operating mode display via LED”, page 41) .
● The DCU indicates system malfunctions by outputting an error code to the display.
10.2 Troubleshooting
Problem Possible causes Remedy
Pumping station will not start
up. None of the LEDs on the
DCU illuminate.
● Current supply in-
terrupted
● Check supply lines to pumping station.
● Check the 24 V DC output voltage at
the “DC out” connection of the built-in
power supply pack.
● Check the plug contacts on the power
supply pack.
● Check connection cable between pow-
er supply pack, backing pump, and tur-
bopump.
● Incorrect operat-
ing voltage
● Note rating plate specifications.
● Supply the correct operating voltage.
● No operating volt-
age present
● Connect operating voltage.
● Electronic drive
unit defective
● Replace electronic drive unit according
to turbopump operating instructions.
● Contact Pfeiffer Vacuum Service.
Pumping station not reaching
final pressure.
● Condensate in the
backing pump
● Open the backing pump gas ballast
valve.
● Gas ballast valve
open
● Close the backing pump gas ballast
valve.
Tbl. 16: Troubleshooting
Malfunctions
51/80