Page
2
of 28
Brightwell 400P
–
July 2022 v1
Pevex Stoves - Brightwell 400P
– Installation & Operating Manual
Important Key Safety Points: Please read before using your stove
WARNING
HOT - HOT - HOT This appliance
and the flue will become HOT
while in
operation and retains its heat for a long period of time after use.
Children, aged or infirm persons & pets should be supervised at all
times and should not be allowed to touch the hot working surfaces
while in use or until the appliance has thoroughly cooled.
Always use the heat proof glove provided when touching the
appliance
All surfaces can be HOT
WARNING! Keep children and pets away
Do NOT cover or leave flammable substances or any combustible
materials on or near the appliance such as soft furnishing,
laundry or curtains
Ensure a Carbon Monoxide (CO) alarm is fitted in the room where
the stove is fitted, we also recommend the installation of a
Smoke Detector as well
Only Approved Fuels to be used on this stove - which are:
Seasoned Wood Logs or Kiln Dried Logs with a moisture level
of less than 20%
Smokeless Mineral Fuels as detailed on pages 18 & 26
Keep all fuels loads 75mm below the AIR holes at the back of the
fire box
Do not overload the Fire box
When COLD - Always empty the Ash Pan out after each time it
is used
Check the flue regularly for any blockages
Do not leave unattended if children are in the room
Do not clean when hot, or whilst fire is still alight
For installation - This Product
is HEAVY - DO NOT try and LIFT it
manually
– Ensure correct and adequate handling facilities are used
for unloading, site handling and installation
First Time of Operation
Before lighting this stove, ensure that all packaging, safety stickers and any
protective wrapping have been removed, and that the glass has been
cleaned, including all fingerprints from the glass.
Ensure that the room is adequately ventilated, the first time the stove is lit; we
would recommend opening windows if possible.
Curing the Paint
– First Time Usage
Open the door by 20mm so the door rope seal is not touching the
body for the first 20 to 30 minutes of burning
Run the appliance at a 25% setting for a 1 hour
Then at a 50% Setting for 1 hour
Then Finally on Full Power 100% for 1 hour
This will then allow the paint the opportunity to fully cure. During this
period it is possible for some fumes and vapours to be given off. We
would recommend keeping children and pets out of the area at this time.
If the paint is not cured correctly it could peel from the stove, so
undertaking the curing process correctly is important
HOT
SURFACES
ALWAYS WEAR
GLOVES WHEN
HOT
ONLY USE
APPROVED FUELS
DO NOT
OVERLOAD THE
FIREBOX
HEAVY
THIS PRODUCT IS
HEAVY FOR
INSTALLTION USE
THE CORRECT
LIFTING
PROCEDURES
FIT A CARBON
MONOXIDE (CO)
ALARM IN THE
ROOM WHERE
THE STOVE IS
CURE THE PAINT
CORRECTLY
