PEUGEOT e-2008, Руководство пользователя

Страница: 65 / 164

64
Driving
6
,
Starting
► With an automatic gearbox , select mode P
or N and press the brake pedal.
► Press the " START/STOP " button while
maintaining pressure on the pedal until the
engine starts.
For Diesel engines , when the temperature is
below zero and/or the engine is cold, starting will
only occur once the preheating warning lamp is
With petrol engines , after a cold start,
preheating the catalytic converter can
cause noticeable engine vibrations for
anything up to 2 minutes while stationary with
the engine running (accelerated idle speed).
If the engine stalls, release the clutch
pedal and fully depress it again, the
engine will restart automatically.
► Immobilise the vehicle, with the engine at
idle.
► With a manual gearbox , ideally put the gear
lever into neutral.
► With an automatic gearbox , ideally select
mode P or N .
► Press the " START/STOP " button..
In some circumstances, it is necessary to turn
the steering wheel to lock the steering column.
If the vehicle is not immobilised, the
steering assistance systems are also cut
Never leave your vehicle with the
electronic key still inside.
Switching on the ignition
without starting the engine
With the electronic key in the passenger
compartment, pressing the “ START/STOP ”
button, without pressing any of the pedals
allows the ignition to be switched on without
starting the engine.
► Press this button again
ignition and allow the vehicle to be locked.
Key not detected
Back-up starting
to enable the engine to be started if the system
fails to detect the key in the recognition zone, or
if the battery in the electronic key is discharged.
► Place and hold the remote control against the
reader.
► With a manual gearbox , place the gear lever
in neutral, then fully depress the clutch pedal.
► With an automatic gearbox or a drive
selector , select mode P , then fully depress the
brake pedal.
► Press the " START/STOP " button.
The engine starts.