www.petsafe.net
5
Key Definitions
Three Color LED:
Shows good or
low battery and indicates Test Mode.
Sound Activated Sensor:
Detects the
sound of your dog’s bark.
Vibration Points:
Deliver the
Vibration Correction.
On/Off Battery Module:
Turns the
collar on and off.
Sound
Activated
Sensor
On/Off
Battery
Module
Three Color LED
Vibration Points
Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is important for
effective operation. The Vibration Points must have direct contact with your dog’s skin
on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is in the “OFF” position.
2. Have your dog standing comfortably (
A
).
3. Center the Vibration Points underneath your dog’s neck, touching
the skin (
B
).
Note: It is sometimes necessary to trim the hair around the Vibration Points to
make sure that contact is consistent.
SÍ
NO
A
Do not shave the pet’s neck as this
may increase the risk of skin irritation.
4. Check the tightness of the Bark Control Collar by
inserting one finger between the strap and the dog’s
neck (
C
). The fit should be snug but not constricting.
5. Allow your dog to wear the collar for several minutes,
then recheck the fit. Check the fit again as your dog
becomes more comfortable with the Bark Control Collar.
6. Trim the collar as follows: (
D
)
a. Mark the desired length of the collar with a pen.
Allow for growth if your dog is young or grows a
thick winter coat.
b. Remove the Bark Control Collar from your dog and
cut off excess.
c. Before placing the Bark Control Collar back onto
your dog, seal the edge of the cut collar by applying a
flame along the frayed edge.
B
C
D
