6
Customer Care Center 1-800-732-2677
ON/OFF Battery Module
The PetSafe
®
Vibration Bark Control Collar is packaged with the battery module installed in the
“OFF” position. To activate the collar, use a coin to turn the Battery Module counter clockwise
until the arrow lines up with the “ON” position. If the collar is not going to be used on the dog
immediately leave it in the “OFF” position.
To Insert and Remove the Battery
Note: Do not install the battery while the Bark Control Collar is on your dog.
1. Align the line on the battery with the triangle on the Bark
Control Collar (
A
).
2. Use a
coin
to turn the battery clockwise until the line points
to the “On” position if you are putting it on the dog or the
“Off ” position if it is not being put on the dog right away (
B
).
3. To remove the battery, turn the battery counter-clockwise
using a coin (
C, D
). DO NOT attempt to cut into or pry
open the battery. Be sure to discard the used battery properly.
This Bark Control Collar utilizes a replaceable PetSafe
®
battery
(RFA-188). This unique battery is designed to make battery
replacement easier and increase water protection.
A replacement PetSafe
®
battery (RFA-188) can be found at
many retailers. Contact the Customer Care Center or visit our
web site at www.petsafe.net to locate a retailer near you.
D
C
A
B
Battery Life
Average battery life is 3 to 6 months, depending on how often your dog barks. However, due
to greater use during your dog’s training, your first battery may not last as long as replacement
batteries. To conserve battery life, turn to the “OFF” position when the Bark Control Collar is not
in use.
Three Color LED
The three color LED indicator shows good or low battery and indicates Test Mode. Good battery
equals 1 flash every 5 seconds with Green LED. Low battery equals 3 flashes every 5 seconds with
the Red LED. If there are no LED lights it is time to change the battery.
LED Function and Response Table
Function
LED Light Response
Unit is on
Green LED Light flashes once every 5 seconds
Low battery condition
Red LED Light flashes 3 times every 5 seconds
Delivering vibration
Red LED Light flashes for each correction
Test Mode
Orange LED flashes
