Petsafe Stubborn Dog In-Ground Fence ZIG00-14658, Руководство по эксплуатации продукта

Страница: 14 / 32

14 +1 (800) 732-2677
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the Long Contact Points
for pets with long or thick hair. Tighten the Contact Points using Test Light Tool (
5A
) one-half
turn beyond finger tight. Check the tightness weekly.
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
5A
1. Remove the screws with a Phillips screwdriver.
2. Remove the Battery Lid (
5B ).
3. Install a 9-volt alkaline battery (
5C
).
4. Replace the Battery Lid ( 5C ).
5. Reinstall the screws. Do not over-tighten the screws.
If the Receiver Indicator Light is flashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the Receiver
Collar. Discharge all power by holding the correction level button down
until the light is no longer illuminated. Replace with a new battery.
A replacement PetSafe
®
9-volt alkaline battery (PAC11-12067) can be
found at many retailers. Contact the Customer Care Center or visit our
web site to locate a retailer near you.
5B 5C
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. Remove the clear plastic cover with the Test Light Tool to
expose the Correction Level Button ( 5D ).
2. With the battery installed, press the Correction Level
Button and release when the Receiver Indicator Light
lights up ( 5E ).
3. The Receiver Indicator Light will emit a series of flashes
representing the Static Correction Level.
4. Increase the Static Correction Level by pressing and
releasing the Correction Level Button within
5 seconds of the previous series of flashes.
5. After setting the Static Correction Level, replace the cover
to protect the Correction Level Button.
5E 5D
The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver
Collar is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to
choose the Static Correction level that best fits your pet.
The Receiver Collar will emit a Warning Tone and vibrate whenever your pet enters the Warning Zone, no matter
what correction level the Receiver Collar is set to. If your pet continues into the Correction Zone, and the Receiver
Collar is set to level 2 or above, he will receive a Static Correction. The Receiver Collar is equipped to automatically
increase the level of Static Correction the longer your pet remains in the Static Correction Zone if the collar is set at
level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, flashing every 4 to 5 seconds when battery replacement
is required. Test your Receiver Collar at least once a month to verify that it is functioning properly and that it
activates at the Boundary Wire.
Step
5