6 1-800-732-2677
Installing Your Wall Entry Pet Door
Measure
1A.
Locate the site for the Wall Entry Pet Door. Locate the studs in
the proposed area. Locate the center between the two studs.
Using a pencil, draw a 5” (12.7 cm) vertical line on center
about 10” to 12” (25.4 cm to 30.5 cm) above the floor.
1B.
Mark the shoulder height of your pet on the vertical line.
Draw a horizontal line through your mark.
Check for electrical and plumbing fixtures that could be in the wall where you wish to place
the pet door.
Tape
2A.
Place the template against the wall. Align the lines on the template
with the lines on the wall. Tape in place.
2B.
Check that the template is square.
2C.
Carefully trace the template with a pencil. Remove the template from
the wall. Take a moment to review the hole location to ensure that
the template is level and that this is the best possible location for the
pet door.
Cut Interior Wall
3A.
Drill out the four corners of the rectangular hole with a
5
⁄
16
”
(8 mm) drill bit.
Helpful Tip:
Use both hands to hold drill steady and
straight at a 90° angle.
3B.
Carefully cut the hole out using a jigsaw or other appropri-
ate cutting device. Cut on line.
Helpful Tip:
When cutting use both hands to hold the
saw slow, steady and straight at a 90° angle.
Step 1
10"-12"
Center Between
Studs
Shoulder Height
1A
1B
2A
2B
2C
Step 2
Step 3
3A
3B
