8 1-800-732-2677
4F.
You are now ready to work from the outside wall.
Line up the three holes on the template with the three holes
that you just drilled. Check for square and tape in position.
4G.
Drill out the four corners of the rectangular hole with a 5⁄16”
(8 mm) drill bit.
Helpful Tip:
Use both hands to hold drill steady and
straight at a 90° angle.
4H.
Carefully cut the hole out using a jigsaw or other appropriate cutting
device. Cut on line.
Helpful Tip:
When cutting use both hands to hold the saw slow,
steady and straight at a 90° angle.
Helpful Tip:
If you are going through vinyl siding it is best
to carefully score and cut the siding before cutting through plywood.
4I.
Fit
Check
Using the B side of the pet door, check the fit. Do
not force fit if it is tight. If the hole is too small, simply remove the
pet door and re-cut or file the hole slightly to enlarge. Do not
cut more than ¹
⁄
₈” (3.2 mm) from your previous cut. Once the
pet door properly goes into the hole, adjust to ensure the unit
is square.
4F
4G
4H
4I
