Petsafe PIG00-10777, Руководство по эксплуатации и обучению

Страница: 24 / 32

24 1-800-732-2677
Troubleshooting
Receiver Collar is not
beeping or correcting.
• Check battery to make sure it is installed properly.
• Check that both lights are lit on the Fence Transmitter. If not, perform the “System Test”
(page 26).
The Receiver Collar is
beeping, but the pet is
not responding to the
Static Correction.
• Test the Receiver Collar with the Test Light walking toward the Boundary Wire.
• If the Test Light flashes, check the fit of the Receiver Collar.
• Trim your pet’s fur where the Contact Points touch the neck and/or switch to the longer
Contact Points.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
The Receiver Collar has
to be held on top of
the Boundary Wire to
activate.
• Replace battery.
• Adjust Boundary Width Control knob clockwise to increase the distance from the Boundary
Wire that the Receiver Collar activates. Verify the Boundary Control Switch is placed at the
proper setting according
to the amount of Boundary Wire used. (See Step 6)
• If using a Double Loop, make sure Boundary Wires are separated at least 5 feet.
• If the Receiver Collar still has to be held on top of the Boundary Wire, perform the
“System Test”.
The Receiver Collar
activates inside the
house.
• Turn the Boundary Width Control knob counterclockwise to decrease the distance from the
Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running within 15 feet of the house. The signal can transmit
through the walls of your house.
• Make sure Boundary Wires are twisted from Boundary to the Fence Transmitter.
The Receiver Indicator
Light is flashing every
4 to 5 seconds and I
have just installed a new
battery.
• To reset the low battery indicator, remove the battery from the Receiver Collar. Discharge all
power by holding the correction level button down until the light is no longer illuminated.
Reinstall battery.
I have an
inconsistent signal.
• Make sure Fence Transmitter is at least 3 feet from large metal objects or appliances.
• Make sure all Boundary Wire turns are gradual with a minimum 3 foot radius.
• Make sure the Boundary Wire is not running parallel to and within 10 feet of electrical wires,
neighboring containment systems, telephone wires, television or antenna cables, or satellite
dishes.
• If a neighboring containment system may be causing an inconsistent signal, move the Boundary
Wire farther away from the neighboring containment system.