5
petsafe.com
How it Works
Using the PetSafe
®
Remote Trainer you can easily improve the communication with you and your dog. When you press
a button on the remote, it sends a signal to your dog’s collar. With three training options
- tone, vibration and static
stimulation - you can ensure you will have a well-trained dog in a short amount of time.
The trainer can be used for off-lead walks in range of 300 metres. Also included is an easy to read digital backlit display
on the remote and a lightweight, waterproof and rechargeable training collar.
Charge the Training Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1.
Plug in and fully charge the remote and the training collar. This can take up to 5 hours.
2.
When fully charged, the green LED on the collar will turn off, and the battery meter on the remote will stop cycling
and appear full.
3.
When the collar and remote are charged, replace their rubber covers.
To Turn the Training Collar On
Press and hold the on/off button until you hear a low to high beep and the green LED
appears, and then release.
Note: The remote is always on, and the display will appear when any button is pressed.
On/Off
Charging
Button
To Turn the Training Collar Off
Port
Press and hold the on/off button until the collar beeps high to low, and then release. The red
LED will be illuminated during the button press and will turn off when the collar turns off.
Quick Tip: When you’re not using the collar, you should turn it off to preserve the battery life.
When storing the collar for long periods, recharge every 4 to 6 weeks.
Test the Remote Trainer
We recommend you experience firsthand how the static stimulation functions. Always begin at the lowest level, and
increase the intensity up to your personal comfort level.
1.
Place one finger over both contact points of the training collar.
2.
Hold your remote approximately 0.5 m from the training collar. Starting at level 0, press the vibration button
continuously for 1 to 2 seconds. You should feel continuous vibration. There is one level of vibration.
3.
Increase the level to 1 for static stimulation. At this level you may not feel the stimulation.
Note: Continuous
stimulation will transmit for no more than 10 continuous seconds. To reactivate, release and repress the button.
4.
Increase the level on the static level adjuster until the sensation begins to feel uncomfortable.
