DE
NL
IT
FR
ES
EN
www.petsafe.net 3
2 www.petsafe.net
• Read this entire guide prior to cutting or modifying an opening in your door or wall. Do not proceed with cut-out or
installation until your Cat Flap is assembled, powered up, programmed for your pet and all steps under “Prepare, Setup
and Test” have been completed.
• Keep these instructions with important papers; be sure to transfer these instructions to the new owner of the property.
• Unauthorised changes or modifications may void the user’s authority to operate this equipment, and void the warranty.
• Radio Systems Corporation does not accept any responsibility for openings that are cut or modified in doors or walls or
any damage caused to doors or walls in forming or modification of such openings, including any costs associated with the
repair or replacement.
• The unit only operates properly while outside temperatures are greater than -20.5° C and less than 55° C. If operating
from the optional rechargeable lithium-ion battery, the battery and Battery Compartment cannot be exposed to
temperatures below 0° C.
• Do not install in a location where the Cat Flap Interior Frame, including the LCD Screen and Battery Compartment, and the
Power Adaptor are exposed to damp or wet conditions or to water or outside elements, such as rain or snow.
• Only use designated Power Adaptor with the product.
• Do not use Power Adaptor in temperatures below 0° C or above 40° C. Power Adaptor for inside use only.
• If homeowner’s door or other application is not level, the Cat Flap must be installed level to swing properly.
• When applying the cutting template, there should be a minimum of 8 cm between the bottom and sides of the door and the
outer edge of the template to maintain the structural integrity of the door.
• Make sure there is nothing on the other side of the door where you will be drilling the holes or cutting the opening.
• Use a manual screwdriver to tighten screws. Do not over-tighten. Over-tightening can strip the screws or warp the
Cat Flap frame.
