Petersen TL-3, Руководство владельца/оператора

Страница: 40 / 172

Petersen Industries, Inc.
TL Owner's Manual
while performing maintenance or service under the body, unless the body is
braced to prevent accidental lowering.
Lock-out/Tag-out Procedure (LOTO)
1. With the vehicle parked on level firm ground, set the parking brake and chock
the wheels.
2. Place operating equipment at lowest potential energy level or position so as not
to be subject to possible free fall, and/or install additional blocking device(s) to
prevent this potential for any raised or elevated equipment such as bodies, tail or
side gates, booms, bucket or other attachments.
3. If work on the bucket is required, place the bucket outside the body by first setting
the outriggers, second, positioning the bucket over the side of the truck and finally,
lowering the boom until the bucket is on the ground.
4. If it is necessary to raise the body during LOTO, the body prop must be in place to
secure the body from falling.
5. Disengage the PTO and shut down the truck engine.
6. Remove the key from the ignition.
7. Using a non-reusable fastener, secure a LOTO tag to the steering wheel indicating
the vehicle is out of service.
8. Relieve stored energy from the hydraulic components by moving each control
handle back and forth several times. Cylinders equipped with either pilot operated
check or counterbalance valves will not function unless under hydraulic power.
Modification to any part of the loader can create a safety hazard and therefore shall not
be made without the manufacturer's written approval. It is important that you use
factory replacement parts to ensure that size and capacity are as the original parts.
It is important that hydraulic components be rated at proper flow and pressure. If your
loader is rebuilt or remounted, mounting procedures and retesting is required in
accordance with factory instructions.
Disconnecting, removing, or disabling any part or component which controls the speed
of the loader is a misuse of the loader.