Peter electronic VersiStart II 11L Series, Инструкции по сборке и пусконаладке

Страница: 8 / 22

VersiStart II 3 ... 15L .. 7
7. Commissioning
The device is to be put into operation in 3 steps:
1. Mounting
2. Connection and
3. Parameter setting
7.1 Mounting instructions
Caution: Danger to life through electric shock!
The following conditions are to be complied with in order to ensure a safe
and reliable operation of the VersiStart II:
1. The device series VersiStart II is to be used under conditions of the
overvoltage category III.
2. Make sure that pollution degree 2 or better, in accordance DIN EN60644-1 /
IEC664, is complied with.
3. The device has to be installed into a housing (min. degree of protection: IP54).
4. The device must be operated without being exposed to contamination by
water, oil, carbon deposits, dust, etc..
Warning:
To avoid heat concentrations, a distance of at least 40mm is to be kept
between cable duct and device.
Place the device vertically on a perpendicular mounting plate with the motor terminals pointing
downwards. The device is to be snap-mounted onto a 35mm top-hat rail according to DIN EN
50022. Underneath the device, no additional heat sources such as heating resistors must be
mounted or arranged.