SINGLE MITRE SAW 50
ENG Rev 1
page 45
Take maximum care when the cutting unit is working
-
Never leave cut workpieces on the working table; remove them immediately after the
machining to avoid having pieces of section bar lying around on the working table
The minimum amount cut off in bar offcut operations = not less than 50 mm
5.3.F
UNCTIONAL CYCLE
1. CHECK connections to ELECTRICAL POWER SOURCE and to COMPRESSED AIR
POWER SOURCE
Figure 31
– Connections checkings
2. MOVE the slide of the slide valve
Figure 32
– Slide valve activation
Содержание Univer 50
