Connecting - Rear Panel
Important:
Before making any connections, switch off the mains power to all components in your system.
1
Power On/Off
The Power switch turns power to the unit on and off.
2
Mains Power Socket
The Mains Power Socket is used with the removable mains power cord to supply your Audiant DP32
DAC preamplifier with power.
Before connecting the DP32 to the mains power, please check the voltage label on the rear panel to
ensure that your amplifier conforms to the power supply in your area. Never attempt to connect the
unit to an incorrect voltage – severe damage may result.
Note:
The unit must always be earthed when connected to mains power. Use the earthed, moulded
mains lead supplied. Never use an unearthed mains plug, socket or adaptor with this unit. The mains
lead supplied may be fitted with a fused plug, depending on local regulations. If this is the case,
always replace this fuse with another of the same type and rating.
3
Mains Fuse
The mains fuse is user serviceable, and should always be replaced with the same type and rating (see
Technical Specifications section).
Ensure your Audiant DP32 is disconnected from the mains power before attempting to change the fuse.
Note:
Fuses do not usually blow without a reason. Any doubts about fuse failure should be conveyed
directly to your Perreaux dealer.
4
Trigger Outputs
Two remote trigger output are provided to control the standby state of any remotely connected
devices. The remote trigger output accepts a mono 3.5mm (
1/8
”) plug. The trigger output voltage is 5V
DC when the amplifier is not in standby and is 0V DC when in standby.
The trigger output plug must meet the specifications shown below:
Sleeve: GND
Tip: Signal
1
2
3
4
6
5
6
7
8
9
10
11
15
12
13
14
16
18
16
17
18
