9
Operation - Front Panel
1
Standby Button
The Standby Button switches the unit between Standby mode (indicated by dim standby LED) and On
(indicated by bright standby LED). The unit should be left in Standby mode when not in use.
2
Source Buttons
The Source Buttons allow you to select the source component that you wish to listen to. The signal
selected is also fed to the Line Out output so that it may be recorded. The input should not be
changed whilst recording.
3
Volume Control
The Volume Control increases/decreases the level of the sound from the outputs of the amplifier.
This control affects the level of the preamplifier outputs. It does not affect the level of the Line Out
connections.
Note:
When the Output Level Switch is set to ‘Fixed’, the volume control has no effect on the volume
level of the preamplifier outputs.
Note:
When Aux2 input is selected and the Aux2 Function Switch is set to ‘HT’, the volume control will
have no effect on the volume level of the preamplifier outputs.
4
Sample Rate Indicator
The Sample Rate Indicator shows the input sample frequency of the selected digital input. All sample
rate frequencies are illuminated while the DP32 cannot lock onto the digital signal. If no sample rate
frequencies are illuminated the input sample frequency is not a multiple of 44.1kHz or 48kHz.
Note:
The Sample Rate Indicator is disabled when an analogue input is selected.
5
Infrared Sensor
The Infrared (IR) Sensor receives commands from the supplied Audiant remote control. Clear
unobstructed line of sight between the remote control and the sensor is required.
1
2
5
4
3
