IDS-305F Hardware Installation Guide
Appendix D - IDS DIN Rail and Wall Mounting
This appendix provides instruction on the following:
• Mounting the IDS Switch on a DIN Rail
• Removing the IDS from the DIN Rail
• Wall Mounting the IDS
Mounting the IDS Switch on a DIN Rail
1
The DIN rail clip will be fixed to the back of the IDS unit when you receive the switch.
2
Position the IDS switch such that the top hooks of the DIN rail clip attach onto the top of the DIN
rail.
3
Rotate the bottom of the IDS switch towards the rail. This will snap the bottom hooks of the DIN
rail clip onto the bottom of the DIN rail.
See diagram below
Removing the IDS from the DIN Rail
1
The DIN rail attachment clip has a slot at the bottom of the latch that is visible beneath the switch
when it is mounted.
2
Insert a flat blade screwdriver into the slot and twist the base to release the clip. Alternatively a
downward force on the clip will release the clip.
3
When the clip is released, pull the bottom of the switch out slightly and remove the switch from the DIN rail.
Wall Mounting the IDS
If you have purchased the optional wall mounting kit then proceed as below:
1
Remove the DIN rail clip from the rear panel on the IDS switch.
2
Attach the wall mount plates to the IDS switch as shown below using the screws provided in the kit.
