i06298377
Engine
Oil
and
Filter
-
Change
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Do not drain the oil when the engine is cold. As the oil
cools, suspended waste particles settle on the
bottom of the oil pan. The waste particles are not
removed with the draining cold oil. Drain the
crankcase with the engine stopped. Drain the
crankcase with the oil warm. This draining method
allows the waste particles that are suspended in the
oil to be drained correctly.
Failure to follow this recommended procedure will
cause the waste particles to be recirculated through
the engine lubrication system with the new oil.
Drain the Engine Oil
After the engine has been run at the normal
operating temperature, stop the engine. Use one of
the following methods to drain the engine crankcase
oil:
• If the engine is equipped with a drain valve, turn
the drain valve knob counterclockwise to drain the
oil. After the oil has drained, turn the drain valve
knob clockwise to close the drain valve.
• If the engine is not equipped with a drain valve,
remove the oil drain plug to allow the oil to drain.
After the oil has drained, the oil drain plug should
be cleaned and installed.
Replace the Oil Filter
NOTICE
Perkins oil filters are built to Perkins specifications.
Use of an oil filter not recommended by Perkins could
result in severe engine damage to the engine bear-
ings, crankshaft, etc., as a result of the larger waste
particles from unfiltered oil entering the engine lubri-
cating system. Only use oil filters recommended by
Perkins.
1.
Remove the oil filter with a suitable tool.
2.
Clean the sealing surface of the oil cooler (1).
Illustration 56
g03890458
3.
Apply clean engine oil to the new oil filter seal (2).
NOTICE
Do not fill the oil filters with oil before installing them.
This oil would not be filtered and could be contami-
nated. Contaminated oil can cause accelerated wear
to engine components or engine damage.
SEBU9075-03
91
