Engines with Factory Installed
Radiators
Illustration 33
g06164610
Typical example
(1) Rear lifting eye
(2) Front lifting eye
i06279447
Product
Storage
(Engine
and
Aftertreatment)
Perkins
are
not
responsible
for
damage
which
may
occur
when
an
engine
is
in
storage
after
a
period
in
service.
Your
Perkins
dealer
or
your
Perkins
distributor
can
assist
in
preparing
the
engine
for
extended
storage
periods.
Condition
for
Storage
The
engine
must
be
stored
in
a
water
proof
building.
The
building
must
be
kept
at
a
constant
temperature.
Engines
that
are
filled
with
Perkins
ELC
will
have
coolant
protection
to
an
ambient
temperature
of
−36°
C
(−32.8°
F).
The
engine
must
not
be
subjected
to
extreme
variations
in
temperature
and
humidity.
Storage Period
An engine can be stored for up to 6 months provided
all the recommendation are adhered to.
Storage Procedure
Keep a record of the procedure that has been
completed on the engine.
Note:
Do not store an engine that has biodiesel in the
fuel system.
1.
Ensure that the engine is clean and dry.
a. If the engine has been operated using biodiesel,
the system must be drained and new filters
installed. The fuel tank will require flushing.
b. Fill the fuel system with an ultra low sulfur fuel.
For more information on acceptable fuels refer
to this Operation and Maintenance Manual,
“Fluid recommendations”. Operate the engine
for 15 minutes in order to remove all biodiesel
from the system.
2.
Drain any water from the primary filter water
separator. Ensure that the fuel tank is full.
3.
The engine oil will not need to be drained in order
to store the engine. Provided the correct
specification of engine oil is used the engine can
be stored for up to 6 months. For the correct
specification of engine oil refer to this Operation
and Maintenance Manual, “Fluid
recommendations”.
4.
Remove the drive belts from the engine.
Sealed Coolant System
Ensure that the cooling system is filled with Perkins
ELC, or an antifreeze that meets “ASTM D6210”
specification.
Open Cooling System
Ensure that all cooling drain plugs have been
opened. Allow the coolant to drain. Install the drain
plugs. Place a vapor phase inhibitor into the system.
The coolant system must be sealed once the vapor
phase inhibitor has been introduced. The effect of the
vapor phase inhibitor will be lost if the cooling system
is open to the atmosphere.
For maintenance procedures ref to this Operation
and Maintenance Manual.
36
SEBU9075-03
