Peri MULTIPROP, Инструкция по сборке и эксплуатации, Страница: 28 / 58

26
13
13
13 8 8
8
7.1
14
14
14
14
MULTIPROP System
Instructions for Assembly and Use – Standard Configuration
A5 Bracing MULTIPROP Towers
Installing the Brace Connec-
tor MPR
The Brace Connector MPR can be
assembled or disassembled temporarily.
The Brace Connector MPR is assembled
at the joints of the MULTIPROP Props.
This similarly applies to all prop arrange-
ments (inner tube – inner tube, inner
tube – outer tube, outer tube – outer
tube).
The Brace Connector MPR can be used
both on the direct connection with
end plates and on the connection with
Connector MPV.
Direct connection of the end plates
The end plate connection must be
secured with 2 MULTIPROP Bolts (8)!
Assembly
1. Remove both Bolts (14) from the
Brace Connector MPR (13).
2. Push Brace Connector MPR over both
end plates.
3. Fasten with both Bolts and secure
with Cotter Pins (14).
(Fig. A5.01a)
If the Brace Connector MPR is to remain
on the prop connection permanently,
1 MULTIPROP Bolt (8) on the side
opposite the connection is sufficient.
(Fig. A5.01b)
Connecting the end plates with
Connector MPV-2
Assembly
1. Remove both Bolts (14) on the Brace
Connector MPR (13).
2. Push the broader opening of the
Brace Connector MPR over both end
plates.
Not possible on the clamping lever
(7.1).
3. Fasten with both Bolts and secure
with Cotter Pins (14).
(Fig. A5.01c)
Fig. A5.01a Fig. A5.01b
Fig. A5.01c
AuV MULTIPROP EX.indb 26 07.01.16 11:56