Peri MULTIPROP, Инструкция по сборке и эксплуатации, Страница: 19 / 58

17
MULTIPROP System
Instructions for Assembly and Use – Standard Configuration
A2 MULTIPROP System
Base MP 50
Technical data
For the permissible load-bearing
capacity, see type test:
– MULTIPROP System with Base
MP 50.
– MULTIPROP Slab Props with
Base MP 50.
– Used to extend the slab prop by
50 cm.
– Automatic centering of the slab prop
by means of centering pins.
– Two clamping claws connect the
Base MP 50 with the slab prop.
– The MULTIPROP Slab Prop can be
mounted on the Base MP 50 with
the inner or outer tube.
Assembly
1. Place Slab Prop (1) on the Base
MP 50 (3).
2. Centering pins (3.3) of the base
engage in the drilled holes of the
base plate (1.8) or head plate (1.9) of
the slab prop. (Fig. A2.17a)
3. Secure clamping claws (3.2) with a
hammer over the base plate or head
plate. (Fig. A2.17b) Base MP 50 is
connected to the slab prop.
Are both clamping claws securely posi-
tioned on the head plate and base plate?
Releasing
Spindle props without load!
1. Open clamping claws using
a hammer.
2. Remove the Base MP 50.
Fig. A2.17a
Fig. A2.17b
3.2
1.9
1
3.3
3.3
3
3.2
1.8
AuV MULTIPROP EX.indb 17 07.01.16 11:55