Performax 241-0968, Руководство пользователя

Страница: 15 / 30

15
CHANGING THE COLLET
The cutting bits for this tool are locked into
place with a collet nut (1) and collet (2)
(Fig. 4). 1/8" and 5/32" collets are used for
holding 1/8" and 5/32" cutting bits and
hobby tool accessory bits. The 1/4" collet
is supplied for holding 1/4" drywall and
small router bits.
To change from one collet size to the
other:
1. Remove bit from the tool.
2. Turn the collet nut counter clockwise
until it can be removed from the motor
shaft (3) (Fig. 4).
3. Pull the collet out of the motor shaft
and insert the new collet.
NOTE: Each collet is the same on both
ends, so either end can be inserted into
the motor shaft.
Re-install the collet nut and slightly tighten
it by hand.
NOTE: Tightening the collet nut without a
bit in the collet will cause the collet hole to
become smaller and make installing bits
difficult. When storing the tool with no bit
installed, leave the collet nut loose.
ASSEMBLY AND OPERATING
Fig. 4