First Time Operation With DMX:
Before you start using this unit, please check there is no transportation damage, should there be any, please
do not use the device and contact your dealer immediately.
• The PFX3000S is designed to be used with water based fog liquid. NEVER OIL BASED.
• Put the smoke machine on a flat stable surface or hang from a suitable truss, make sure you use a safety
wire. Make sure no one can put any body part close to the heater output.
• Unscrew the lid on the fluid bottle, fill up with a suitable fog liquid, do not to overfill. Screw the plastic cap
back on and ensure the tank never runs dry during operation.
• Plug in a suitable DMX controller via the 3 pin DMX socket.
• Connect the PFX3000S to a suitable mains supply.
• When you first turn on the smoke machine you will need to wait for around 3-5 minutes for the heater to
warm up and then you will gain access to the controls.
• Set a DMX address via the 4 button menu display.
• Once heated the smoke machine can be controlled by 1 channels of DMX, 1=volume output.
Overhead Rigging:
The installation must be carried out by a qualified engineer only. Improper installation can result in injuries or
damage to property. Overhead rigging requires experience, working loads should be adhered to and certified
materials should be used. The installed device should be regularly inspected for safety.
• Make sure the working area is clear from people and obstructions during rigging, de-rigging and servicing.
• Locate the smoke machine in a well ventilated area away from flammable materials and liquids. The smoke
machine needs to be 50cm away from surrounding walls and fixtures.
• The smoke machine should be installed out of reach of people and not where people are seated, walking or standing.
• When mounting make sure the installation point can take the weight.
• Make sure a safety chain or wire is always used and can take the weight of the smoke machine. The safety
bond should not be used as a primary support.
• The machine should be well fixed and free from swinging.
• Do not cover any ventilation holes.
• Disconnect the power when the machine is not in use.
• The operator must make sure the smoke machine has been installed correctly to all the necessary
guidelines before each use. The installation should be inspected every 6 months.
Maintenance:
• Do not allow liquid to become contaminated. Always replace the cap on the liquid container immediately
after filling.
• After every 40 hours of operation, or if the unit is not to be used for one month, It is recommended to run a
cleaning solution of 20% clear vinegar and 80% distilled water through the system to prevent clogging in the
heater. This should be carried out in a well-ventilated room.
• Always empty the fluid and water tanks after every use. Use a dry cloth to wipe down the outside of the fog
machine. Make sure the power cable is disconnected from the mains supply.
• Make sure the mains cable is in impeccable condition and should be replaced when a small defect is
detected.
• All other maintenance should be carried out by a qualified engineer.
