1/01 E Service Instructions
17
Machine Sizes 115 and 132
(Fig. 22)
Screw in chain 1 which connects
solenoid Y80 with catch 2 with
the aid of threaded pin 3 to be
turned in deep enough and lock it
so that between catch 2 and catch
stop 4 is a gap of s = 0.6 - 1.0 mm
when the solenoid is dead. At this
position, S81 must be in actuated
state.
Switch S82 should be aligned so
that it is operated by the catch
when the solenoid is energized
(by activating the manual clutch -
refer to "Manual Cranking" in the
Operating Instructions manual).
Machine Sizes 168
(Fig. 23)
S81
Y80
Fig. 22
S82
1
4
2
3
Important!
When the catch rests on the knife
beam contour with Y80 being
dead, S82 must not yet be oper-
ated (except machine size 168).
Locking pin 1 is guided by bush 2
supported by machine frame 3.
Solenoid Y80 withdraws this pin
against pull-back spring 4 so that
a gap of s = 2 - 3 mm is obtained
between knife beam slide surface
5 on the frame and the face of the
locking pin.
Adjust stop 6 in the solenoid axis
so that S81 is actuated when the
solenoid is in its de-energised
state.
Adjust switch S82 so that it is
actuated by the stop when the
solenoid is in its
energised state (by activating the
manual clutch - refer to "Manual
Cranking" in the Operating
Instructions manual).
5
3
1
2
4
S82 S81 Y80
6
Fig. 23
Содержание 115 TV
Страница 5: ...1 01 E Service Instructions 5 Fig 2 ...