36
Radar Motion Sensor RMS-FRW
Safety
3.2
General safety instructions
The operator of the system is responsible in terms of planning, mounting, set-up, operating and maintenance.
Installation and set-up of all devices must be performed by a trained professional only.
Protection of operating personnel and the system is not ensured if the module is not used in accordance with its in-
tended purpose.
Conformance to the laws and regulations applicable to the specified or intended usage should be ensured. The de-
vices are only approved for proper professional usage in accordance with the intended purposes. Improper handling
will void any claim made under the warranty and any manufacturer's liability.
Only use recommended original accessories.
If serious faults occur, stop using the device. Secure the device against inadvertent operation. In the event of repairs,
send the device to Fuchs. Independent interventions and separate modifications are dangerous and will
void the warranty and exclude the manufacturer from any liability.
Dispose of the defective device in accordance with country-specific legal requirements.
Correctly dispose of the sensor by handing it over to a designated collection point for the recycling of electrical and
electronic equipment waste.
In order to satisfy the safety requirements specified in EN60950-1 and UL508, the sensor must
be operated from an SELV supply where output is limited to 100 W.
The output can be limited using a T2.5 A fuse.
This device must be installed and maintained only by qualified, trained personnel.
