42
Radar Motion Sensor RMS-FRW
Installation
The plug has the following pin assignment:
Connecting the RMS-FRW
The sensor is supplied with power via the connection plug. It is also possible to directly connect
to the relay contact on the connection plug. Proceed as follows:
1.
Connect the cable to the power supply.
2.
Insert the socket on the cable into the connection plug on the printed circuit board.
3.
Connect the safety sensor terminal on the controller (door control) with the relay contacts or
the corresponding voltage or frequency output of the movement detector. For this, use the
suitable wires of the cable coming from the RMS-FRW.
4.
For all further steps, refer to Set-up (see section 6)
5.
After completing all the settings for the sensor, push the cover over the base plate. Hook the
cover on to the upper end of the base plate and press the cover until it clicks into place.
Pin-out according 8-pin plug strip
Pin-out according 8-pin plug strip
(Frequency output)
(Relay output)
Pin
Signal
Pin
Signal
1
2
3
4
5
6
7
8
+12 ... 36 V DC
GND
Relay 1
Relay 1
Relay 2
Relay 2
No Connection
No Connection
Color
Color
white
brown
green
yellow
grey
pink
blue
red
Pin-out according 8-pin plug strip
(Voltage output)
Pin
Signal
Color
1
2
3
4
5
6
7
8
+12 ... 36 V DC
GND
Uout +
Uout -
No Connection
No Connection
No Connection
No Connection
white
brown
green
yellow
grey
pink
blue
red
1
2
3
4
5
6
7
8
+12 ... 36 V DC
GND
Fout +
Uin -
Uin +
No Connection
No Connection
No Connection
white
brown
green
yellow
grey
pink
blue
red
