Pentek Cobalt 78661, Руководство по установке

Страница: 22 / 32

Pentek Model 78661 Installation Manual Page 21
Rev.: 1.7
2.10 PCIe Carrier Connectors
The following subsections describe the power and signal connectors on the PCIe car−
rier. Refer to
Figure 2−7 on the prior page for location of the connectors on the PCB.
2.10.1 Power Connector
The PCIe carrier uses a 6−pin power connector,
labeled
J23
, to 12V power to the XMC mod−
ule. This is a standard PCI Express power connector
used in PCs with a PCI Express bus.
Pins 1, 2, and 3 are +12 VDC
Pins 4, 5, and 6 are ground
NOTE: You must provide a power source to this
connector or the XMC module will not operate.
Pentek includes a PCIe to Molex adapter cable (part # 002.21790)
with the Model 78661 shipment.
2.10.2 JTAG Connector
The JTAG J4 connector provides a connection to download programs and to
perform boundary−scan tests on PCIe carrier devices. This connector is
reserved for Pentek factory use only. The pinout for this 14−pin header is
given in the following table.
2.10.3 Fan Connector
Connector J8 on the PCIe carrier PCB provides a +12VDC power source for
use by the cooling fan.
Table 2
−
10: JTAG J4 Connector
Signal Pin Number Pin Number Signal
Gnd 1 2 +3.3 V
Gnd 3 4 TMS
Gnd 5 6 TCK
Gnd 7 8 TDO
Gnd 9 10 TDI
Gnd 11 12 TRST_N
Gnd 13 14 No Connection
1
3
5
7
9
11
13
2
4
6
8
10
12
14