Pentek Model 78661 Installation Manual
Page 11
Rev.: 1.7
2.3
Removing XMC Module from PCIe Carrier
1) From the solder side of the Model 78661 assembly (side opposite the 71661 XMC),
unscrew the four pan−head Phillips mounting screws, as identified below.
2) From the XMC module side,
GENTLY
, pull on the XMC card to disengage the card’s
connectors from the PCIe carrier’s XMC connectors.
After jumper or switch changes, replace the XMC onto the PCIe carrier as follows.
1) Position the 71661 XMC module’s front panel into the PCIe carrier’s panel opening
from behind the PCIe carrier slot panel, and align the XMC module so that the
connectors on the XMC card are aligned over the connectors on the PCIe carrier.
2)
GENTLY but firmly
, press down on the areas of the XMC opposite the connectors to
fully seat the card’s connectors into the carrier. The connectors on the XMC should
connect smoothly with the corresponding connectors on the carrier.
3) From the solder side of the PCIe carrier, secure the XMC to the carrier by screwing the
four pan−head Phillips mounting screws (those removed above) through the PCIe
carrier into the XMC module.
CAUTION
Perform all steps at a static
−
controlled work workstation.
Figure 2
−
2: Removing 71661 XMC from PCIe Carrier
XMC
Module
XMC
Mounting
Screws
Cooling
Assembly
