Pentek Cobalt 78661, Руководство по установке

Страница: 16 / 32

Pentek Model 78661 Installation Manual Page 15
Rev.: 1.7
2.5 XMC Module Jumpers
The following describes user operating parameters that are set by jumper block
J28
on
the Model 71661 PCB. This jumper block is located on the connector side of the Model
71661 main PCB (Pentek part number 320−71600). An assembly drawing of the con−
nector side of the PCB is provided below, showing the location of jumper block
J28 .
NOTE: To access J28 , you must remove the XMC module from the PCIe carrier, as
described in Section 2.3 .
Jumper J28 , pins 1−3, are used to program eFUSE in the Virtex−6 FPGA. Refer to the
Xilinx Virtex−6 FPGA Configuration Guide (Xilinx document UG360) for further infor−
mation about using this capability.
Table 2
−
5: Virtex
−
6 Program eFUSE Enable
−
Jumper Block J28
Jumper Pins Function Installed Removed
Pins 1
−
3 Virtex
−
6 Program eFUSE Enabled Disabled *
Pins 2
−
4 no function
− −
* Factory Default Setting
J2
8
Figure 2
−
4: Model 71661 Main PCB Connector Side Jumpers
J28