76180 EM -43/73-
Yellow (19p)
Orange (18p)
Brown (16p)
Red (17p)
White (14p)
②
The aperture of lens must change similarly when the aperture value (Av) is set in opening,
the middle, and the minimum with the Av dial.
③
Detach the lens from camera, and depress the release button, and make the camera long
exposure condition. Confirm there is neither dust nor scratch on the CCD of 0-T600.
22-9. [CONF] CF card cover SW
①
The camera turns OFF when the CF card cover is opened during the camera is turned ON.
②
Close the CF card cover and turn the main SW to OFF. When the main SW is turned ON
again, the camera must be turned ON.
23. [ADJ] Adjustment with Programmed Software (SLR operation)
[NOTE] The adjusting method of this camera is basically the same as *ist (27830).
[Required equipment] Programmed software for 76180 (for SLR operation), Battery adaptor
(use D-BG1), Regulated DC power supply (8V
・
3A), AC adaptor (D-AC10),
Temporary bottom
cover (Hand made/exclusive item), Master lens 76180
The other items are the same as 27830 (*ist)
AF positioning jig (Square) for 27830, AF positioning jig (Cross) for 27250, AF chart for 2m x2
(Exclusive item), AF master lens for 2m, FA Macro 50mmF2.8, Light source (Shutter tester),
Diaphragm set ring F8 (KA-0-1A), I/F buffer cable for 27250
For the other items, refer to the table of “Jigs, Tools and Testers”.
[CAUTION] When the following parts are replaced, do the adjustment as follows.
0-T100 ----- All adjustment.
0-J100, 0-J201 ----- AE adjustment (A)
0-M100, 0-B52 ----- AF adjustment (B)
[ADJ]
①
Solder I/F buffer cable on the main board.
[NOTE] Pass the cable through into the strap lug to prevent damage
of the soldered lands.
②
Install the temporary bottom cover and battery cover to the camera,
and then connect the AC adaptor to the camera.
③
Run the programmed software (for 76180), and then adjust the camera according to the
instructed on the screen. About the flow of adjusting, refer to the programmed software flow
chart.
[The flow of adjustment is as follows]
Product select menu (Select *istD)
→
76180 test program*
→
Main menu
→
Eeprom
checking (START)
→
Exposure adjustments (A)
→
AF adjustments (B)
→
Eeprom checking
(END)
→
Main menu (Finish)
④
After adjusting camera, remove I/F buffer cable
and AC adaptor from camera.
A422
A423
