Pentair PENTEK PSD25PB, Инструкция по установке и эксплуатации

Страница: 7 / 60

7 P1063 (10-03-19)
Pentair Pentek
*
Solar Drive Hardware
The Pentair Pentek Solar Drive controller consists of several components, as shown in
Figure 5. The unit has five wire glands: one large gland for a motor cable (middle), two
glands for solar PV and AC source cables (right side), and two glands for data cables (left
side), a float switch sensor or other optional sensor. There is direct access to the power
and signal terminals on the DIN rail once the enclosure door is removed.
The Pentair Pentek Solar Drive controller should be mounted on a wall or other vertical
surface using the back bracket (see Figure 5 below). On the back side of the unit there
are four set screws used to hang the unit on the back bracket. More detailed mounting
instructions are shown below.
Figure 5: Pentair Pentek Solar Drive Hardware
Fix the back bracket to the
support surface by inserting
four screws (not included)
through the 4 holes in the
back bracket
1
Once the Pentair Pentek
Solar Drive is in place on
the back bracket, install the
shoulder bolt to secure the
unit to the bracket
3
Make sure all 4 set screws
are used to hang the Pentair
Pentek Solar Drive onto the
back bracket
2
Back Bracket (Wall Mount)
Heatsink
AC Source
ON/OFF Switch
Signal Wire
Glands
Back View Front View
Ground
Electrode Lug
Motor ON/OFF
Switch
Power Wire Glands
(Motor, Solar and AC Source)
Mounting
Holes
Shoulder Bolt