Pentair PENTEK PSD25PB, Инструкция по установке и эксплуатации

Страница: 5 / 60

5 P1063 (10-03-19)
Pentair Pentek
*
Solar Drive Specifications
Input Specification:
- AC grid operating voltage
†
: 115 Vac 60 Hz, 1-phase
230 Vac 50/60 Hz, 1-phase
- Maximum AC input current: 12 Amps
- Maximum solar open circuit voltage: 400 Vdc ††
- Maximum solar PV current in series: 9 Amps
†††
- Earth-ground connected to chassis
†
Suitable for use on a circuit capable of delivering not more than 5000 rms symmetrical
amps, 230 volts maximum.
††
DC PV input terminals shall only be connected to listed photovoltaic modules and panels
that comply with UL 1703.
†††
Suitable for use on a circuit capable of delivering not more than 13.5 rms symmetrical
amps, 400 volts maximum.
Output Specification:
- Maximum output current: 10 Arms (1-phase motors)
- Maximum output current: 8 Arms (3-phase motors)
- Maximum power sustained: 2500 W
Protections:
- Input AC grid over-current: 12A fused terminal block
- Short-circuit, ground-fault, over-temperature, overload, over-voltage, over-current
- Automatic dry well protection and pump locked rotor protection
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code(NEC) and any additional local codes.
ELECTRICAL MECHANICAL
AC source operating voltage: 115-230V Degree of protection: TYPE 3R
AC Source phase & frequency: 1 phase only!
50/60Hz Enclosure material: Aluminum
Operating temperature: -40 ̊C to 40 ̊C
Solar PV open circuit voltage: 400V Dimensions: 18”x10”x5”
Max PV panel current in series: 9A AC Source Terminals: AWG #10-16
Max Single phase AC motor current: 10A Solar Terminals: AWG #10-16
Max Three phase AC motor current: 8A Motor terminal: AWG #10-16
Float Sensor terminals: AWG #14-20
WARNING:
Carefully check the motor load specifications, AC source voltage available and solar PV
array maximum power point voltage to set up the system properly using this manual!
If 120-Vac is used as AC grid input, maximum load that can be connected is 1400W!