Pentair MasterTemp 200, Инструкция по установке и эксплуатации

Страница: 47 / 68

P/N 474131 Rev. M 8/2020 MasterTemp Pool and Spa Heater
47
Error and Fault Codes
Table 10. Heater Error and Fault Codes
Fault Condi � on Error Code
Displayed
Note Troubleshoo �ng
Water pressure switch
open
ERR PS If water fl ow is established the
the error is cleared and normal
opera � on is resumed.
No water fl ow thru
heater
Hi temperature limit
switch open
ERR HLS When the temperature falls
below 135°F the error is cleared
and normal opera � on is
resumed.
Water temperature a � er
the 1 st pass through the
heater exchanger is more
than 135°F.
Air fl ow switch open ERR AFS If adequate air fl ow through the
blower is established within 60
seconds the heater will resume
normal opera � on. If the error is
not corrected within 60 seconds
the heater will need to turned
o ff by pressing the HEATER OFF
bu � on.
The blower is not on or
air thru it is being
restricted
Igni � on Control Module ERR IGN To clear the error the HEATER
OFF bu � on must be pressed.
The Igni � on Control
Module was not able to
ignite the heater.
Automa � c gas shu � o ff ERR AGS The front panel bu � ons will be
disabled. To reset the heater,
cycle power.
Water temperature a � er
the 2 nd pass thru the heat
exchanger is more than
140°F
Excessive stack fl ue
temperature
ERR SFS The front panel bu � ons will be
disabled. To reset the heater,
cycle power.
The temperature of the
stack fl ue is more than
480°F
Open stack fl ue sensor E05
Shorted stack flue
sensor
E06 The front panel bu � ons will be
disabled. To reset the heater,
cycle power.
Follow diagram on page
53
Open water
temperature sensor
E01 To clear the error the HEATER
OFF bu � on must be pressed.
Follow diagram on page
52
Shorted water
temperature sensor
126 Follow diagram on page
52
Follow diagram on page
53
Section 1. Troubleshooting