Pentair IntelliFlo VS+ SVRS, Инструкция по установке и эксплуатации

Страница: 22 / 60

12
IntelliFlo VS+ SVRS Installation and User’s Guide
Settings: Language
To access the language menu:
1. Check that the green power LED is on.
2. Press the
Menu button. “Settings” is displayed.
3. Press the Select button. “Pump Address” is displayed.
4. Use the Up or Down arrow button to scroll to “Language”.
5. Press the Select button to access the language menu.
6. Press Select to highlight current Language in use.
7. Press the Enter button to select the desired language for the control panel. To cancel any changes,
press the Escape button to exit edit mode without saving.
8. Press the Escape button to exit.
Settings: Set Minimum Speed (RPM)
The minimum pump speed can be set from 1100 RPM to 1700 RPM. The default setting is 1100 RPM.
To access the Set Minimum Speed menu:
1. Check that the green power LED is on.
2. Press the
Menu button. “Settings” is displayed.
3. Press the Select button. “Pump Address” is displayed.
4. Use the Up or Down arrow button to scroll to “Set Min Speed”.
5. Press the Select button to change the setting. The cursor will appear in the first number column
(ones)
6. Press Up or Down arrow button to change the pump’s minimum speed setting from 1100 to 1700
RPM.
7. Press the Enter button to save the setting. To cancel any changes, press the Escape button to exit
edit mode without saving.
8. Press the Escape button to exit.
Settings: Set Maximum Speed (RPM)
The maximum speed can be set from 1900 RPM to 3450 RPM. The default setting is 3450. This setting is
used to set the maximum running speed of the pump. When the pump is set to Priming "Enabled" the pump will
ramp up to and run at the Maximum Speed setting to attain the prime. A Service Professional must set the
Maximum Speed of the pump to not exceed the maximum flow rate of the system on which it will operate.
CAUTION: The Maximum Flow rate setting should be set so the system never operates at or above a 25"
vacuum.
To access the Set Maximum Speed menu:
1. Check that the green power LED is on.
2. Press the
Menu button. “Settings” is displayed.
3. Press the Select button. “Pump Address” is displayed.
4. Use the Up or Down arrow button to scroll to “Set Max Speed”.
5. Press the Select button to change the setting. The cursor will appear in the first number column
(ones)
6. Press Up or Down arrow button to change the pump’s maximum speed setting from 1900 to 3450
RPM.
7. Press the Enter button to save the setting. Press the Escape button to exit. To cancel any changes,
press the Escape button to exit edit mode without saving.