!
3m / 10ft
OK
3.1 - Unwind the cable and stretch it out
completely so that it has no kinks.
3.2 - Attach the floating cable to the controller box by
inserting it with the notch on the connector lined- up with
the groove in the socket on the controller box.
3.3 - Position the power supply so that it is approximately
in the middle of the long side of the pool at a distance of
3m /10ft from the water.
Plug in the power supply and leave it in the OFF position.
It is recommended to protect it from rain and direct sun
exposure.
3.4 - Grab the robotic cleaner by the top handle. Put it into
the pool. Release the Robotic cleaner and let it sink to the
floor of the pool. Make sure that the floating cable is free
of any obstructions.
3.5 - Turn the Controller box ON.
The Robotic cleaner will now operate until the end of the
cleaning cycle (1h30 unless otherwise programmed thru
external timer mode).
To stop the robotic cleaner before the end of the cleaning
cycle, press the Power button for about one second. A red
LED will blink meaning the robotic cleaner is now turned
off.
3.6 - Using the floating cable, bring the
Robotic cleaner to the pool’s edge.
Using the handle, remove slowly the
Robotic Cleaner from the pool and hold
it vertically to let the water drain out.
Start-Up
DO NOT PULL THE ROBOTIC CLEANER
FROM THE POOL USING THE CABLE.
Содержание BLUESTORM
Страница 11: ...9...