AMERBRITE
™
White LED Pool Lamp Installation and User’s Guide
ii
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Risk of Electrical Shock.
Connect only to a branch circuit
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified
electrician if you cannot verify that the circuit is protected by a GFCI.
This light must be connected only to a supply circuit that is protected by a ground-fault
circuit-interrupter (GFCI). Such a GFCI should be provided by the installer and should
be tested on a routine basis. To test the GFCI, push the test button. The GFCI should
interrupt power. Push the reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI interrupts power to the light
without the test button being pushed, a ground current is present, indicating the
possibility of an electric shock. Do not use this light. Disconnect the light and have the
problem corrected by a qualified service representative before using.
Important Safety Information for Pentair Niche and Light
Installation
•
All Niche and Light installations must conform with all
codes. If local codes mandate a cord seal, use Pentair
plastic niches (P/N 79206600 and P/N 79206700) and
Cord Seal Kit (P/N 670044).
•
Under no circumstances replace lights by splicing wire
under water or behind niche.
THE AMERBRITE
®
WHITE LED LAMP, CANNOT BE USED ON A
DIMMER CIRCUIT. USING A DIMMER SWITCH WILL RESULT IN
PERMANENT DAMAGE TO THE LAMP.
