Pentair Pool Products Kreepy kadet, Руководство пользователя

Страница: 7 / 15

IV. Adjustments
After completing the installat i o n , t u rn the pool pump on. Your Kre epy Kadet should be moving about the
pool at ap p rox i m at e ly 8-12 feet per minu t e. A l l ow the pump to run for a couple of minutes to allow air to
cy cle out of the system. Check each of the fo l l owing initial adjustments to your Kre epy Kadet at this time.
Hose Length
IMPORTANT: The pump must be on when you check the hose length. The hose contracts when the
pump is operating and will look longer when the pump is off.
With the cleaner operating, position it at the furthest point of the pool from where it’s attached. (It is
easy to position it in the pool by moving it about with your pool pole and brush.) The hose should be
long enough to reach to the end of the pool, plus one hose section. If necessary, remove extra hose
sections from the center portion of hose. Removing center hose sections avoids having to disturb the
hose weight placement. Save extra hose sections for use as needed for replacement.
Return Line Water Flow
IMPORTANT: The water flow from your return line can push the cleaner’s hose and affect its
performance. It may cause the cleaner to steer away from the end of the pool where the return line is
located, or it may cause it to remain in one section of the pool. To correct this, use the eyeball diverter
included with your cleaner.
To install the e yeball diverter:
• First make sure your pool pump is off. Remove the original eyeball diverter from the return
line at the pool by unscrewing the lock ring.
• Replace the original eyeball diverter with the Kreepy Kadet’s eyeball diverter.
• Replace the lock ring and tighten. Make sure the opening of the eyeball diverter points in the
proper direction before tightening fully. See “Eyeball Diverter Position.”
Eyeball Diverter
Wire Diverter (optional)
Pool Deck
Pool
Wall
Return
Line
Eyeball
Fitting
Eyeball
Diverter
Lock (Retaining)
Ring
Figure 14