Rev. G 4-23-1
2
7
P/N 619339
12. Reconnect the power to a circuit in accordance with the appropriate electrical connections. See Section
III, Electrical Connections. If the light is not on, press the switch on the transformer case
once
.
WARNING
This is an electrical appliance. Unsupervised use of this product by children can result in injury
and/or death.
SECTION V.
STORAGE AND WINTERIZING INSTRUCTIONS
1.
It is common practice to drain the water level to a point below the skimmer and the light, for winterizing.
2.
For storable pools:
remove power from the unit by taking the power cords’ three-prong plug and
disconnecting it from its electrical outlet.
3.
Remove the snap-on cord cap by inserting a slotted screwdriver into the access hole and prying
upwards, as illustrated in Figure 9, Section IV Relamping Instructions.
4.
The wire connectors should be gently disconnected and pushed into the rear of the bulb assembly.
5.
Push red cap/plug into rear of bulb assembly to seal it.
6.
Remove the bulb assembly nut.
7.
Remove the bulb assembly by pulling on the flow director while pushing the bulb assembly from the
outside of the pool.
NOTE
The fitting body, threaded wall flange and gaskets may remain attached to the pool wall when winterizing, but
should be removed if pool is to be stored.
8.
For storable pools:
remove the transformer from its mounting by lifting up and out.
9.
Place all the parts together in a box and store indoors.
When reinstalling bulb assembly next season do not use petroleum base product.
CAUTION
Do not use any petroleum base lubricant. Petroleum base products will destroy plastic parts.
Lubricate o-ring with a silicone lubricant only. A new o-ring should be used each time the bulb
assembly is removed.
Содержание AquaLuminator
Страница 1: ......
