Rev. G 4-23-1
2
5
P/N 619339
SECTION III. ELECTRICAL CONNECTIONS
FOR STORABLE POOLS
1.
Connect the wire connectors from the bulb assembly to the
wire connectors attached to the snap-on cord cap.
NOTE
There is no polarity (no positive or negative) to the wires, either
connection will work.
2.
Snap the cap onto the end of the body and turn so that the
electrical cord is pointing down.
3.
Mount the transformer on the vertical wall using the single
screw provided.
4.
Plug the power cord’s 2-prong plug into an appropriate 220V
ground fault circuit interrupter protected receptacle at least 3.0 meters from the pool.
5.
If the light is not on, press the switch on the transformer case
once
.
WARNING
Risk of electric shock. Connect only to a grounding-type receptacle protected by a ground
fault circuit interrupter. Do not use extension cords for connection. Failure to do so can
result in death or severe personal injury.
øøøWHAT IS A ground fault circuit interrupter???
A ëGround Fault Circuit Interrupterí is an electrical safety device designed to measure electri-
cal leakage in a circuit. It is far more sensitive than a standard circuit breaker. Ground fault
circuit interrupter equipped breakers and outlet combinations react to unsafe leakage and shut
the power off before electrical shock injury can occur. Any electrical device used within 3.0
meters of a pool must be protected by a ground fault circuit interrupter equipped outlet or a
ground fault circuit interrupter equipped circuit breaker and be intended for such use.
SECTION IV. RELAMPING INSTRUCTIONS
WARNING
Risk of electric shock. Disconnect power before servicing this unit. Failure to disconnect
power can result in death or severe personal injury.
1.
It is desirable to reduce the water level to the lower edge of the flow director. This makes bulb assembly
replacement easier, but it is not mandatory.
2.
Remove power from the unit by taking the power cord’s 2-prong plug and disconnecting it from its
electrical outlet, or in the case of a hard-wired application, by turning the respective circuit breaker to
the OFF position.
O-Ring—use silicone lubricant
only. Do not use any
petroleum products.
Key
Keyway
Figure 8.
Содержание AquaLuminator
Страница 1: ......
