Pello Reddi, Руководство пользователя, Страница: 15 / 32

15
Noodle Holder
Brake Noodle
Brake Arm
While continuing to hold the brake arms together,
slide the end of the brake noodle into the slot on the
noodle holder. Let go of the brake arms. Then slide
the rubber boot over the end of the noodle.
Now that the brake is connected, squeeze it
several times to make sure it is working properly.
Spin the wheel, it should spin freely, if not repeat
steps 1-3.
Step 3/3
Rubber boot
Connect the Front Brake (Rover & Reyes)
Your Rover or Reyes is equipped with disc brakes. Your brakes have
been adjusted before they arrived to you. Once you completed
installing the front wheel from the “Install and Secure the Front
Wheel” you should spin the wheel to ensure it rotates smoothly
and squeeze the front brake several times to ensure the wheel
is properly mounted in the front fork. If the brake is rubbing or
the wheel is not spinning freely please go back to the “Install and
secure the front wheel” section again and repeat these steps to
ensure proper wheel and rotor alignment.
*Please note that disc brakes may take a few times of stopping
before they are working to their full potential. For the first ride it
is recommended that you find a level location to ride. Ride the
bike and stop several times on a level and safe location free from
obstacles and vehicles, this will allow the disc pads to properly
‘bed’ to the disc rotors. Brakes are essential safety devices so care
should be taken to make sure they work correctly.