pellenc 58W00001, Руководство по эксплуатации

Страница: 27 / 48

SOIL CULTIVATOR CULTIVION ALPHA
58_163161-A
3. Position the blade mounting assembly (13) on the
output shaft (25), aligning the mark on the blade
mounting part (23) with the required mark (-4 to +4)
on the protective casing (26).
4. Push the work tool support into the casing (26) until
it clicks into place.
5. Place the nut (27) in the recess position provided on
the blade mounting part (23).
6. Fit the washer (28) and screw (29).
7. Tighten the screw (29) using a 5 mm hex socket and
a torque wrench.
Important
Tightening torque: 12 N.m.
The correct setting is reached when the machine moves back with almost no effort by the user.
Ideally, the work is done while moving backwards.
To find the optimum setting, put the working tool in position “0”.
• If the machine tends to sink too far into the ground and does reverse towards the used, dismount the work tool
following the procedure explained above and tilt it towards "+" side with respect to the position "0".
• If the machine tends not to dig deeply, and comes out of the soil jerking abruptly, tilt the work tool into a position
towards the “-” side.
• Repeat the operation as many times as necessary until you find the optimum setting.
27