Pelican 1354 NaturSoft Custom Salt Free
Water Softener/Conditioner
© 2013 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Rev B
Page 8
www.pelicanwater.com
(877) 842-1635
Whole House Salt Free Water Softener/Conditioner Tank Installation
Figure 4
1. Determine the size and material of your incoming water supply line and choose the appropriate fit-
tings required to connect it to the filter head.
CAUTION:
Do not over-tighten any of the fittings during installation.
2. Install the fitting onto the INLET and OUTLET sides of the filter head.
3. Connect the incoming water supply to the INLET side of the filter head.
4. Connect the outgoing water supply to the OUTLET side of the filter head.
Media Soak
Figure 5
1. Open a cold water faucet or test spigot close to the downstream of the Water Softener.
2. Turn the water back on at the main shut-off valve allowing the system to fill with water. The air
being displaced will escape through the open fixture downstream.
3. Fill the Pelican Salt Free Water Softener/Conditioner Tank full until water comes out of the
downstream fixture. Bypass the tank using the bypass installed around the system. This will allow
you to isolate the system and restore water supply to the home/building during the media soak.
4. Allow the tank to soak for at least 60 minutes.
IN
OUT
INLET
OUTLET
IN
OUT
Outgoing
Water to
House
Pre-Filter
Incoming
Water
Supply
Wall
Wall
Customer-Provided
Connection
Bypass
(Recommended)
Salt Free Water Softener/Conditioner
IN
OUT
INLET
OUTLET
IN
OUT
Outgoing
Water to
House
Pre-Filter
Incoming
Water
Supply
Wall
Wall
Customer-Provided
Connection
Bypass
(Recommended)
Salt Free Water Softener/Conditioner
