Pelgrim PK354, Руководство пользователя

Страница: 16 / 18

uw kookplaat
30 31
uw kookplaat
Removing the decorative glass cover
•
Open the decorative lid. Carefully lift the decorative
º
glass cover out of the hinged brackets.
Placing the decorative glass cover
•
Carefully lower the decorative glass cover into the
º
hinged brackets. The decorative lid must only be
placed
vertically (see illustration). If this does not work,
then the hinges need to be replaced. Never randomly
switch the location of the hinges, because if they are
wrongly located, then the lid cannot be brought to
a standstill and it can drop down.
Attention! Always
check if the decorative lid can be brought to a standstill
after re-installing it. Close the decorative glass cover.
7 Faults 6 Maintenance
FAULT CAUSE SOLUTION
A burner does not ignite. Plug not in socket.
Fuse defective/fuse in
meter cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas tap closed.
Fault in the gas network.
Control knob not kept
pressed in long enough or
far enough.
Push the plug into the
socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the
sparkplug.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Open the main gas tap.
Check with your gas
supplier.
Keep the control knob
pressed in far enough
between high and low.
Table
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first by checking the points mentioned below.
Phone the service department if the advice given below does not help. Only authorised
personnel may carry out work on the gas connection or the mains power supply. Damage
caused by incorrect connection, incorrect installation or incorrect use is not covered by
the warranty. In the case of faults visit the internet site ‘www.atag.nl’.