Pelegrin Tarragon, Руководство по эксплуатации и полетной документации для пилотов

Страница: 55 / 76

Pilots Operating Handbook
55/76
YL-MFG
Revision 7, Issue 1 4/6/2016
7.5.9 Circuit breaker panel
Circuit breaker panel has all the corresponding labels. The picture shows the circuit breaker current
ratings:
7.5.10 Dynon Skyview Avionics
This aircraft has all of the avionics and engine instrument systems integrated in Dynon Skyview.
The front cockpit is equipped with a 10” Dynon Skyview touch display, and the rear cockpit has a
redundant 7” display. They are both connected with all the corresponding equipment into one
integrated system. For proper operation of Dynon Skyview, refer to the “Skyview Pilot’s User’s
Guide”.
NOTE: Front Dynon Skyview, for exporting flight logs and updating, has a USB port built
above the Skyview into the instrument panel. To access the USB port on rear cockpit Dynon
Skyview, remove the 4 screws holding it in place to access the USB port on back of screen.
7.6 Pitot Heat
When outside air conditions are in favor of icing, it is recommended to use pitot heat. To operate
pitot heat, turn on the switch PITOT in front cockpit switch panel.
CAUTION: This airplane is not certified for flying IFR; do not fly in clouds or fog. Using pitot
heat does not permit flying in clouds, fog or other IFR conditions.
NOTE: It is recommended to use pitot heat whenever the temperature is below 10
o
C and there
is visible moisture in air up to an altitude of 10000 ft, always when flying higher then 10000 ft
and always when flying in rain.