pela tools 50640, Руководство пользователя

Страница: 28 / 34

Lubrication
Ball bearings on blade guide assemblies and blade
wheels are permanently sealed and require no
lubrication.
Lightly lubricate the anvil screw with # 2 pipe
grease. Change gearbox oil after the first 90 days
of use. Then change every six months.
To change gearbox oil:
1. Disconnect the machine from the power
source.
2. Place the saw arm in horizontal position.
3. Remove the screws (A, Fig. 17) from the
gearbox and remove the cover plate and
gasket.
4. Empty the gearbox of oil.
5. Place the saw arm in the horizontal position
again. Wipe off the remaining oil with a cloth.
6. Fill the gearbox with approximately 0.3 litres of
gearbox oil.
7. Replace gasket and lid. Secure the cover with
the screws.
8. Connect the machine to the power source.
Maintenance
Warning!
Disconnect the machine from the power source
before making any repairs or adjustments.
Failure to do so may result in serious injury.
1. Keep all surfaces clean and free of rust, slag,
chips and accumulated coolant.
2. Do not use compressed air to clean the band
saw. Compressed air can force chips into guide
bearings and other critical areas of the saw.
3. Use a small brush or cleaning brush to remove
metal particles.
4. Wipe with a clean, dry cloth and oil all
unpainted surfaces with light machine oil.
5. Keep the blade rails clean and free of metal
chips.
6. Check the hinge bearings to make sure they are
set correctly and can be rotated freely.
Cleaning brush
WARNING!
Do not attempt to adjust the saw blade brush when
the machine is running, adjust it only when the
machine’s power cable has been removed from the
power source!
Failure to do so may result in serious injury.
It is important that the saw blade cleaning brush is
correctly adjusted and in good condition.
Replace the brush if it gets damaged or worn out.
The service life of the saw blade will be greatly
shortened if the brush is not adjusted, damaged or
worn out.