Pegasus FlyAway Kit
30
___________________________________________________________________
Columbia Weather Systems, Inc.
The SAMPLE command
SAMPLE: This command is used to display the current sensor
readings in a one line record format (the same format as the
datalog). The record starts with the letter S followed by the date and
time of the sample, followed by the sensor values and ends with a
check sum value. All of these fields are comma delimited.
Example:
S,02/11/98,11:09,36WD,003WS,00.06R,072RH,29.88P1,+050.59T1,+070.77T2,+068.23T3,
+064.60T4,04.43LW,0.00X1,0.00X2,6007ok
Where, WD is wind direction, WS is wind speed in MPH, R is rain
fall in inches, RH is relative humidity percentage, P1 is barometric
pressure in Inches-Hg, T1 through T4 are the four temperature
sensors in degrees F, LW is leaf wetness in volts, X1 is typically
solar radiation (5.00 volts equals 2000 Weather Master 2000-2) and
X2 is used for additional sensors (X1 and X2 channels are not
available with the Pegasus FlyAway Kit).
Temperature channels that are not defined or connected will have a
+255.00 reading.
Wind direction is displayed in a 64 degree compass as follows:
0 N
4 NNE
8 NE
12 ENE
16 E
20 ESE
24 SE
28 SSE
32 S
36 SSW
40 SW
44 WSW
48 W
52 WNW
56 NW
60 NNW
The Short commands
WD: will display wind direction in a 64 compass points
WS: will display wind speed in MPH
R1: will display the rain fall for the day in inches
RH: will display relative humidity percentage
P1: will display the barometric pressure in inches-Hg
