3
7
8
9
24
20
21
13
22
3
13
17
15
16
23
Grease
18
19
8
Installing the AI device
Grease
Grease
CAUTION
CAUTION
Always turn off the power, unplug the machine from the outlet
and then only well-qualified technicians should install the AI device.
5.
After installing bracket
5
and motor
11
as shown on the
previous page, check the following to make a fine adjustment.
(Figs. 3 and 5)
・
Check to make sure magnet
15
on lever
13
is aligned with
sensor
16
or
17
when differential feed lever
3
is at the top or
bottom of its travel. If it is not, adjust the position of screws
9
in each slot. Adjustment is made by loosening screws
9
that
connect link
7
and
8
. After this adjustment, tighten screws
9
.
To make a fine adjustment loosen screw
18
for sensor
16
and
screw
19
for sensor
17
. Adjust the position of sensors
16
and
17
in the slot. After this adjustment is made, tighten screws
18
and
19
.
・
Check to make sure that links
7
and
8
move easily by moving
differential feed lever
3
.
6.
Grease the joints on the links (see the arrows).
(Fig. 6)
CAUTION
CAUTION
To prevent the formation of rust and move each link
smoothly, be sure to grease the joints on the links.
7.
Attach covers
20
and
21
. (Fig. 7)
Note
Link
8
should not touch groove
22
on cover
20
.
8.
Install cover
23
.
Insert the cords from the rotation detector and control panel
into hole
24
on the table. (Fig. 8)
