- 44 -
5.
Push the child restraint firmly into the
vehicle seat (A) and pull the vehicle belt (B)
in order to tighten the seat, eliminating any
slack.
6.
Make sure that the belt passes through
the opened lockoff clips and then close
them on both sides following the procedure
shown in picture (C and D).
7.
Picture shows the correct belt pattern
when the product is installed in the forward
facing mode using a lap belt.
Attach the TOP TETHER strap to your vehicle
following instructions at page 24.
Picture shows the correct belt pattern when
the product is installed in the forward facing
mode using a lap belt and top tether.
Verify that the child restraint is secure. A
secure child restraint will not move more
than 2.5 cm (1 inch) near the seat belt
anchors.
Important Note:
The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate.
5
6
A
D
C
B
7
Installing your child restraint in the vehicle - Forward Facing mode