PeerlessBoilers PBC-34, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 65

A. GENERAL
1. Series PBC™ boilers are supplied completely
assembled as packaged boilers. The package should
be inspected for damage upon receipt; any damage to
the unit should be reported to the shipping company
and wholesaler. The boiler should be stored in a
clean, dry area.
2. Carefully read these instructions and be sure to
understand the function of all connections prior to
beginning installation. Contact your PB Heat, LLC
Representative for help in answering questions.
3. This boiler must be installed by a qualified contractor.
The boiler warranty may be voided if the boiler is not
installed correctly.
4. A hot water boiler installed above radiation or as
required by the Authority having jurisdiction, must be
provided with a low water fuel cut-off device either as
part of the boiler or at the time of installation.
5. Series PBC™ boilers are capable of producing
instantaneous domestic hot water to the dwelling. Hot
water over 125°F can cause severe scald burns
instantly. If utilizing the domestic water production
features of the unit, be sure to:
a. Install a temperature limiting device per the device
manufacturer’s instructions to reduce scald hazard.
b. Set the temperature limiting device to the lowest
practical temperature setting.
c. Always feel water before bathing or showering.
d. Do not leave children, the disabled, or the elderly
unattended while bathing.
e. Additional point of use temperature limiting
devices may be required at the fixtures to reduce
scald hazard.
B. CODES & REGULATIONS
1. Installation and repairs are to be performed in strict
accordance with the requirements of state and local
regulating agencies and codes dealing with boiler and
gas appliance installation.
2. In the absence of local requirements the following
should be followed:
a. ASME Boiler and Pressure Vessel Code, Section
IV - “Heating Boilers”
b. ASME Boiler and Pressure Vessel Code, Section
VI - “Recommended Rules for the Care and
Operation of Heating Boilers”
c. ANSI Z223.1/NFPA 54 - “National Fuel Gas Code”
d. ANSI/NFPA 70 - “National Electrical Code”
e. ANSI/NFPA 211 - “Chimneys, Fireplaces, Vents
and Solid Fuel Burning Appliances”
3. Where required by the authority having jurisdiction,
the installation must conform to the Standard for
Controls and Safety Devices for Automatically Fired
Boilers, ANSI/ASME CSD-1.
** Please read if installing in Massachusetts**
Massachusetts requires manufacturers of Side Wall
Vented boilers to provide the following information
from the Massachusetts code:
•
A hard wired carbon monoxide detector with an
alarm and battery back-up must be installed on
the floor level where the gas equipment is to be
installed AND on each additional level of the
dwelling, building or structure served by the side
wall horizontal vented gas fueled equipment.
•
In the event that the side wall horizontally vented
gas fueled equipment is installed in a crawl space
or an attic, the hard wired carbon monoxide
detector with alarm and battery back-up may be
installed on the next adjacent floor level.
•
Detector(s) must be installed by qualified licensed
professionals.
•
APPROVED CARBON MONOXIDE
DETECTORS: Each carbon monoxide detector
shall comply with NFPA 720 and be ANSI/UL
2034 listed and IAS certified.
•
SIGNAGE: A metal or plastic identification plate
shall be permanently mounted to the exterior of
the building at a minimum height of eight (8) feet
above grade directly in line with the exhaust vent
terminal for the horizontally vented gas fueled
heating appliance or equipment. The sign shall
read, in print size no less than one-half (1/2) inch
in size,
“GAS VENT DIRECTLY BELOW.
KEEP CLEAR OF ALL OBSTRUCTIONS” .
2
PREINSTALLATION
1. PREINSTALLATION
Liquefied Petroleum (LP) Gas or Propane is heavier
than air and, in the event of a leak, may collect in low
areas such as basements or floor drains. The gas
may then ignite resulting in a fire or explosion.
WARNING
⚠
DANGER
– Water temperatures over 125°F
– (52°C) can cause severe burns
– instantly, or death from scalds.
– Children, the disabled, and the
– elderly are at the highest risk of
– being scalded.
– Feel water before bathing or showering.
– Read this manual in its entirety before setting
domestic hot water setpoint.
– A temperature limiting device (listed to ASSE 1070
or ASSE 1017) is required.