11 of 14
ISSUED: 04-24-08 SHEET #: 055-9257-9 02-28-14
Visit the Peerless Web Site at www.peerless-av.com
For customer care call 1-800-865-2112
Attach adapter plate (
B
) to projector using one screw (
J, K, L or M
) for each channel as shown below. Tighten
all screws, while keeping the center of gravity. Be sure that adapter plate (
B
) is straight. Adjust the feet of the
channels to keep the adapter plate level. Tighten all screws with 4 mm security allen wrench (
I
) while keeping the
center of gravity. If M3 x 8 mm screws (
J
) are used, tighten using 2 mm security allen wrench (
H
).
NOTE:
Projectors will require different size screws for mounting. Use a combination of screws (
J, K, L or M
) and
foot adjustment that will result in channels of adapter plate (
B
) fitting tightly against projector.
Important:
In order
to properly engage the threads in the mounting holes, the screw must be turned at least 3 full turns.
NOTE:
If using screw (
J
), place washer (
G
) between screw (
J
) and foot of channel.
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
CAUTION
J, K, L
or M
7
B
Slide connection block with projector into projector mount assembly (
A
) as shown. Push in and tighten captive
screw to secure projector to projector mount assembly (
A
).
CONNECTION BLOCK
A
FOOT OF CHANNEL
FRONT OF MOUNT
• Always use an assistant or mechanical lifting equipment to safely lift and position the projector.
WARNING
8
ARROW
INDICATES
FRONT OF
MOUNT
CAPTIVE SCREW
EE or FF
